75056C
1.REMOVE REAR ROOF DRIP SIDE FINISH MOULDING SUB-ASSEMBLY LH
|
Protective Tape |
Apply protective tape around the rear roof drip side finish moulding sub-assembly LH.
|
Remove in this Direction |
Using a moulding remover, disengage the 3 clips as shown in the illustration to remove the rear roof drip side finish moulding sub-assembly LH.
Remove the 2 clips from the rear roof drip side finish moulding sub-assembly LH.
Remove the cap and gasket.
75055C
2.REMOVE REAR ROOF DRIP SIDE FINISH MOULDING SUB-ASSEMBLY RH
Use the same procedure as for the LH side.
3.REMOVE ROOF HEADLINING ASSEMBLY
75607B
4.REMOVE ROOF TOP MOULDING SUB-ASSEMBLY
Remove the 7 nuts and roof top moulding sub-assembly as shown in the illustration.
|
Remove in this Direction | - | - |