75607B
1.INSTALL ROOF TOP MOULDING SUB-ASSEMBLY
Install the roof top moulding sub-assembly with the 7 nuts as shown in the illustration.
|
Install in this Direction | - | - |
2.INSTALL ROOF HEADLINING ASSEMBLY
75056C
3.INSTALL REAR ROOF DRIP SIDE FINISH MOULDING SUB-ASSEMBLY LH
Install a new gasket and new cap.
Install 2 new clips to the rear roof drip side finish moulding sub-assembly LH.
|
Install in this Direction |
Engage the 3 clips as shown in the illustration to install the rear roof drip side finish moulding sub-assembly LH.
75055C
4.INSTALL REAR ROOF DRIP SIDE FINISH MOULDING SUB-ASSEMBLY RH
Use the same procedure as for the LH side.