Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM
RM3210E _56 Audio / Visual / Telematics _047510 AUDIO / VIDEO _0243397 AUDIO AND VISUAL SYSTEM C

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  B15F7  Certification ECU Vehicle Information Reading/Writing Process Malfunction  


DESCRIPTION

This DTC is stored when items controlled by the certification ECU (smart key ECU assembly) cannot be customized via the audio and visual system vehicle customization screen.

HINT:

The certification ECU (smart key ECU assembly) controls the smart key system related items that are customizable via the audio and visual system vehicle customization screen.


DTC No. Detection Item DTC Detection Condition Trouble Area
B15F7 Certification ECU Vehicle Information Reading/Writing Process Malfunction Certification ECU (smart key ECU assembly) vehicle setting processing error
·

CAN communication system

·

Smart key system

·

Certification ECU (smart key ECU assembly)

·

Radio and display receiver assembly



CAUTION / NOTICE / HINT

NOTICE:

Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.


PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Use the GTS to check if the CAN communication system is functioning normally.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING

OK:

CAN communication DTCs are not output.



Result:
Proceed to
OK
NG



OK

2.CHECK SMART KEY SYSTEM

NG

2.CHECK SMART KEY SYSTEM
a.

Check if the smart key system is malfunctioning.

for Entry Function: Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM(for Entry Function)>HOW TO PROCEED WITH TROUBLESHOOTING

for Start Function: Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM(for Start Function)>HOW TO PROCEED WITH TROUBLESHOOTING

HINT:

Customization may not be possible if the smart key system is malfunctioning.


OK:

The smart key system is not malfunctioning.



Result:
Proceed to
OK
NG



OK

3.CHECK CUSTOMIZE ITEMS

NG

3.CHECK CUSTOMIZE ITEMS
a.

Make a note of the customizable items for the certification ECU related system.

HINT:

The items shown as customizable via the audio and visual system vehicle customization screen can also be changed using the GTS. In the following step, the GTS will be used.


i.

To match-up the items on the audio and visual system vehicle customization screen with the items on the GTS, check the customize parameters list for the smart key system related items that can be customized via the audio and visual system vehicle customization screen.

for Start Function: Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM(for Start Function)>CUSTOMIZE PARAMETERS

for Entry Function: Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM(for Entry Function)>CUSTOMIZE PARAMETERS



b.

Using the GTS, confirm that it is possible to change the settings of the customize parameters that are available for customization via the audio and visual system vehicle customization screen.

OK:

The items available for customization via the audio and visual system vehicle customization screen can be customized successfully using the GTS.



Result:
Proceed to
OK
NG



OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)