Home › Audio / Visual / Telematics › AUDIO / VIDEO › STEREO COMPONENT AMPLIFIER
RM3210E _56 Audio / Visual / Telematics _047510 AUDIO / VIDEO _0243399 STEREO COMPONENT AMPLIFIER A

AUDIO / VIDEO  STEREO COMPONENT AMPLIFIER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during stereo component amplifier assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Parking assist monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>CALIBRATION

CAUTION:
B401522

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


PROCEDURE

Hide 1.REMOVE FRONT SEAT ASSEMBLY LH

Hide 86183D 2.REMOVE AUDIO AMPLIFIER COVER

a.
E341731C01
0,0 0,0 false
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


Pull the audio amplifier cover in the direction indicated by the arrow (1) shown in the illustration to disengage the 2 clips.


b.

Pull the audio amplifier cover in the direction indicated by the arrow (2) shown in the illustration to disengage the guide and remove the audio amplifier cover.


Hide 86280 3.REMOVE STEREO COMPONENT AMPLIFIER ASSEMBLY

a.
E341732

Disengage the clamp.


b.

Disconnect the 2 connectors.


c.
E341733

Remove the 2 bolts and remove the stereo component amplifier assembly.