This DTC is stored when the main body ECU (multiplex network body ECU) detects malfunctions in the automatic high beam system.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B124B | Automatic High Beam System | Malfunction in automatic high beam system | ·
Forward recognition camera system ·
lane departure alert system ·
Pre-crash safety system ·
SFI system (w/ Canister Pump Module) ·
SFI system (w/o Canister Pump Module) ·
Electronically controlled brake system ·
CAN communication system ·
Forward recognition camera ·
Main body ECU (multiplex network body ECU) |
- |
Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.
Confirm that there are no CAN communication system malfunctions before performing the following inspection.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM
Speed sensor malfunction
Yaw rate sensor malfunction
Steering sensor malfunction
CAN communication system
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: System Select / Health Check.
Check for DTCs.
| Result | Proceed to |
|---|---|
| Only DTC B124B is output | A |
| DTC B124B and other DTCs are output | B |
A
B
Check if a dynamic radar cruise control system, lane departure alert system and pre-crash safety system warning message is displayed on the combination meter assembly.
Click hereEngine / Hybrid System>CRUISE CONTROL>FORWARD RECOGNITION CAMERA SYSTEM>DIAGNOSIS SYSTEM
No dynamic radar cruise control system, lane departure alert system and pre-crash safety system warning messages are displayed.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereEngine / Hybrid System>CRUISE CONTROL>FORWARD RECOGNITION CAMERA SYSTEM>PROBLEM SYMPTOMS TABLE