Home › Engine / Hybrid System › CRUISE CONTROL › MILLIMETER WAVE RADAR SENSOR
RM3210E _51 Engine / Hybrid System _047527 CRUISE CONTROL _0244353 MILLIMETER WAVE RADAR SENSOR A

CRUISE CONTROL  MILLIMETER WAVE RADAR SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

If the millimeter wave radar sensor assembly has been struck or dropped, replace the millimeter wave radar sensor assembly with a new one.


PROCEDURE

Hide 88211B 1.INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY

NOTICE:

If the front bumper assembly or radiator grill has been replaced, check that the beam axis change mechanism is at the standard position (centered).


a.
E336349N01
1.688,0.625 1.844,0.823 0.156,0.198 10 false A 2.344,0.271 2.5,0.469 0.156,0.198 10 false B

Set beam axis to the standard position.

i.

Turn the bolt so that the beam axis change mechanism is positioned as shown in the illustration.

Specified Condition:
Difference between (A) and (B):

1 mm (0.0394 in.) or less




b.
E336346C02
2.656,1.167 2.781,1.344 0.125,0.177 10 true 1 0.594,1.104 0.719,1.281 0.125,0.177 10 true 2 2.229,0.563 2.354,0.74 0.125,0.177 10 true 3 1.042,0.563 1.167,0.74 0.125,0.177 10 true 4
V100135

Bolt
V100136

Screw


Engage the 2 guides.


c.

Tighten the 2 bolts and 2 screws on the millimeter wave radar sensor assembly.

Torque:
Bolt : 2.5 N*m (25 kgf*cm, 22 in.*lbf)

HINT:

Tighten the bolts in the order shown in the illustration.



d.

Connect the connector.


Hide 53289A 2.INSTALL RADIATOR SUPPORT OPENING COVER

Hide 3.ADJUST MILLIMETER WAVE RADAR SENSOR

a.

When the millimeter wave radar sensor assembly or No. 1 millimeter wave radar sensor bracket is replaced with a new one, adjustment of the radar sensor beam axis must be performed.

Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT