Home › Engine / Hybrid System › 2ZR-FXE ENGINE CONTROL › CAMSHAFT POSITION SENSOR
RM3210E _51 Engine / Hybrid System _047494 2ZR-FXE ENGINE CONTROL _0244551 CAMSHAFT POSITION SENSOR A

2ZR-FXE ENGINE CONTROL  CAMSHAFT POSITION SENSOR  REMOVAL  


PROCEDURE

Hide 12601B 1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 11101E 2.REMOVE CAMSHAFT POSITION SENSOR

a.
A375018

Disconnect the No. 1 fuel vapor feed hose from the fuel vapor feed pipe.


b.
A375019

Disconnect the camshaft position sensor connector.


c.

Remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.

NOTICE:

If a camshaft position sensor has been struck or dropped, replace it.