Home › Engine / Hybrid System › 2ZR-FXE ENGINE CONTROL › IGNITION COIL AND SPARK PLUG
RM3210E _51 Engine / Hybrid System _047494 2ZR-FXE ENGINE CONTROL _0244553 IGNITION COIL AND SPARK PLUG A

2ZR-FXE ENGINE CONTROL  IGNITION COIL AND SPARK PLUG  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during ignition coil assembly or spark plug removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Replacement of ignition coil assembly

·

Replacement of spark plug


Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)w/ Canister Pump Module
(Click here)w/o Canister Pump Module

PROCEDURE

Hide 12601B 1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 2.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

Hide 3.REMOVE NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL (for LHD)

Hide 4.REMOVE NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL (for RHD)

Hide 5.REMOVE WATER GUARD PLATE LH

Hide 6.REMOVE COWL BODY MOUNTING REINFORCEMENT LH

Hide 7.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY

Hide 19500 8.REMOVE IGNITION COIL ASSEMBLY

a.
A375025

Disconnect the 4 ignition coil assembly connectors.


b.
A375024

Remove the 4 bolts and 4 ignition coil assemblies from the cylinder head cover sub-assembly.

NOTICE:

If an ignition coil assembly has been struck or dropped, replace it.


HINT:

Arrange the removed parts in the correct order.



Hide 19100P 9.REMOVE SPARK PLUG

a.
A375026

Remove the 4 spark plugs from the cylinder head sub-assembly.

NOTICE:

If a spark plug has been struck or dropped, replace it.


HINT:

Arrange the removed parts in the correct order.