Home › Engine / Hybrid System › 2ZR-FXE ENGINE CONTROL › HEATED OXYGEN SENSOR
RM3210E _51 Engine / Hybrid System _047494 2ZR-FXE ENGINE CONTROL _0241786 HEATED OXYGEN SENSOR A

2ZR-FXE ENGINE CONTROL  HEATED OXYGEN SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during heated oxygen sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: w/ Canister Pump Module

·

Heated oxygen sensor*1

·

Gas leak from exhaust system is repaired


Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)w/ Canister Pump Module
(Click here)w/o Canister Pump Module

PROCEDURE

Hide 51442 1.REMOVE NO. 2 ENGINE UNDER COVER

Hide 57533B 2.REMOVE FRONT CENTER FLOOR BRACE

a.
A375035

Remove the 4 bolts and front center floor brace.


Hide 89465 3.REMOVE HEATED OXYGEN SENSOR

CAUTION:
A344784

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


a.
A378546C01
2.76,1.833 2.875,1.917 2.875,1.917 2.99,1.917 false 3.042,1.854 3.354,2.052 0.313,0.198 10 false *1
*1 Wire Harness Clamp Bracket


Disconnect the heated oxygen sensor connector.


b.

Remove the wire harness clamp.


c.

Remove the wire harness clamp bracket from the heated oxygen sensor.


d.
A375037N01
2.104,1.552 1.927,1.552 1.927,1.552 1.656,0.844 true 2.115,1.479 2.438,1.646 0.323,0.167 10 true SST

Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly (TWC: Rear Catalyst).

SST
09224-00011  

NOTICE:

If the heated oxygen sensor has been struck or dropped, replace it.