Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM
RM3210E _58 Vehicle Interior _047534 HEATING / AIR CONDITIONING _0244634 AIR CONDITIONING SYSTEM C

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  B1245  Lost Communication with Wiper ECU LIN  


DESCRIPTION

The air conditioning amplifier assembly and windshield wiper relay assembly communicate via LIN communication.

The air conditioning amplifier assembly stores this DTC if communication becomes abnormal.

DTC No. Detection Item DTC Detection Condition Trouble Area Memory
B1245 Lost Communication with Wiper ECU LIN Lost communication with windshield wiper relay assembly
·

Harness or connector between windshield wiper relay assembly and IG power source

·

Harness or connector between windshield wiper relay assembly and body ground

·

LIN communication system

·

Windshield wiper relay assembly


Memorized
(10 sec. or more)*

*: The air conditioning amplifier assembly stores this DTC if the malfunction has occurred for the period of time indicated in the brackets.


WIRING DIAGRAM

E282266E23
1.552,0.875 2.167,1.073 0.615,0.198 10 false MPX1 1.635,1.406 2.25,1.604 0.615,0.198 10 false WIG 1.781,1.927 2.24,2.146 0.458,0.219 10 false E 2.021,1.313 2.396,1.542 0.375,0.229 10 false 16 2.01,1.823 2.604,2.094 0.594,0.271 10 false 12 2.625,1.552 3.688,1.844 1.063,0.292 10 false ECU-IG1 NO. 4 3.885,1.385 4.854,1.813 0.969,0.427 10 false from IG1-NO. 1 Relay 4.76,2.51 7.104,2.875 2.344,0.365 10 false Air Conditioning Amplifier Assembly 4.771,2.333 5.385,2.531 0.615,0.198 10 false F58 5.24,0.885 5.854,1.083 0.615,0.198 10 false SCLI 2.021,0.719 2.635,0.917 0.615,0.198 10 false 14 4.99,0.698 5.604,0.896 0.615,0.198 10 false 15 0.5,2.542 2.844,2.906 2.344,0.365 10 false Windshield Wiper Relay Assembly 0.51,2.375 1.125,2.573 0.615,0.198 10 false F43 0.938,3.198 2.729,3.479 1.792,0.281 10 false : LIN Communication Line

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK FOR DTC
a.

Check for DTCs.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM>DTC CHECK / CLEAR

Body Electrical > Air Conditioner > Trouble Codes
50001 121

Result:
Result Proceed to
DTC B1373 is output A
DTC B1373 is not output B



A

B

2.CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER RELAY ASSEMBLY - IG POWER SOURCE)
2.CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER RELAY ASSEMBLY - IG POWER SOURCE)
a.

Disconnect the F43 windshield wiper relay assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
F43-16 (WIG) - Body ground Power switch on (IG) 11 to 14 V
F43-16 (WIG) - Body ground Power switch off Below 1 V



Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER RELAY ASSEMBLY - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER RELAY ASSEMBLY - BODY GROUND)
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F43-12 (E) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

4.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - WINDSHIELD WIPER RELAY ASSEMBLY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - WINDSHIELD WIPER RELAY ASSEMBLY)
a.

Disconnect the F58 air conditioning amplifier assembly connector.


b.

Disconnect the O1 air conditioning thermistor assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F43-14 (MPX1) - F58-15 (SCLI) Always Below 1 Ω
F43-14 (MPX1) or F58-15 (SCLI) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

REPLACE WINDSHIELD WIPER RELAY ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR