Home › Vehicle Exterior › WIPER / WASHER › WIPER ECU
RM3210E _59 Vehicle Exterior _047514 WIPER / WASHER _0244888 WIPER ECU A

WIPER / WASHER  WIPER ECU  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during windshield wiper relay assembly removal/installation are shown below.

Necessary Procedures after parts removed/installed/replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Parking assist monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>CALIBRATION

PROCEDURE

Hide 1.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 85940 2.REMOVE WINDSHIELD WIPER RELAY ASSEMBLY

a.
E337476

Remove the bolt.


b.

Disengage the guide.


c.

Disconnect the connector to remove the windshield wiper relay assembly.