Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › IMMOBILISER SYSTEM
RM3210E _58 Vehicle Interior _047507 THEFT DETERRENT / KEYLESS ENTRY _0244661 IMMOBILISER SYSTEM C

THEFT DETERRENT / KEYLESS ENTRY  IMMOBILISER SYSTEM  B279C95  Engine Immobiliser System Incorrect Assembly  


DESCRIPTION

If a hybrid vehicle control ECU that is incompatible with the immobiliser system is installed, the hybrid vehicle control ECU will store this DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
B279C95 Engine Immobiliser System Incorrect Assembly A hybrid vehicle control ECU that is incompatible with the immobiliser system is installed (1-trip detection logic*). Hybrid vehicle control ECU DTC output confirmation operation:

Check for DTCs.



*: Only detected while a malfunction is present.


Vehicle Condition and Fail-safe Function when Malfunction Detected
Vehicle Condition when Malfunction Detected Fail-safe Function when Malfunction Detected
Hybrid control system cannot be started -

Related Data List and Active Test
DTC No. Data List and Active Test
B279C95 -

CAUTION / NOTICE / HINT

NOTICE:
·

When using the GTS with the power switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.

·

After performing repairs, confirm that no DTCs are output by performing "DTC Output Confirmation Operation."

·

When replacing the hybrid vehicle control ECU, refer to Service Bulletin.



PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>IMMOBILISER SYSTEM>DTC CHECK / CLEAR

Powertrain > Hybrid Control > Clear DTCs
50002 236

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Check for DTCs.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>IMMOBILISER SYSTEM>DTC CHECK / CLEAR

Powertrain > Hybrid Control > Trouble Codes
50001 236
HINT:

Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.


OK:

B279C95 is not output.



Result:
Result Proceed to
DTC B279C95 is not output A
DTC B279C95 is output B



A

B

3.REPLACE CURRENT HYBRID VEHICLE CONTROL ECU WITH PROPER HYBRID VEHICLE CONTROL ECU
3.REPLACE CURRENT HYBRID VEHICLE CONTROL ECU WITH PROPER HYBRID VEHICLE CONTROL ECU
a.

Replace the current hybrid vehicle control ECU with a proper hybrid vehicle control ECU.

Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID VEHICLE CONTROL ECU>REMOVAL


Result:
Proceed to
NEXT



NEXT

END