The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during hybrid battery thermistor removal/installation are shown below.
Orange wire harnesses and connectors indicate high-voltage circuits. To prevent electric shock, always follow the procedure described in the repair manual.
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>PRECAUTION
To prevent electric shock, wear insulated gloves when working on wire harnesses and components of the high voltage system.
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
G92Z0
2.REMOVE HV BATTERY JUNCTION BLOCK ASSEMBLY
G920Q
3.REMOVE NO. 1 HYBRID BATTERY SHIELD SUB-ASSEMBLY
Be sure to wear insulated gloves and protective goggles.
Remove the 4 nuts.
| *1 | No. 1 Hybrid Battery Shield Sub-assembly |
| *2 | No. 2 Hybrid Battery Shield Sub-assembly |
|
Pull Back |
Pull back the No. 2 hybrid battery shield sub-assembly and remove the No. 1 hybrid battery shield sub-assembly from the HV battery.
Pull back the No. 2 hybrid battery shield sub-assembly until it is separated from the stud bolt of the No. 1 hybrid battery shield sub-assembly.
G92D1
4.REMOVE NO. 1 HYBRID BATTERY INTAKE DUCT
Be sure to wear insulated gloves and protective goggles.
Disengage the claw of hybrid battery thermistor (sensor portion) and disconnect the hybrid battery thermistor from the No. 1 hybrid battery intake duct.
Disengage the claw to remove the No. 1 hybrid battery intake duct from the HV battery.
G9282
5.REMOVE HYBRID BATTERY THERMISTOR
Be sure to wear insulated gloves and protective goggles.
Disengage the clamp.
Disengage the 2 claws and remove the No. 1 hybrid battery packing from the HV battery.
Disengage the clamp.
Disconnect the battery voltage sensor connector.
Disengage the 4 clamps.
Disengage the 3 claws of the hybrid battery thermistor (sensor portions) and remove the hybrid battery thermistor from the HV battery.