Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › WATER PUMP WITH MOTOR
RM3210E _51 Engine / Hybrid System _047524 HYBRID / BATTERY CONTROL _0244769 WATER PUMP WITH MOTOR A

HYBRID / BATTERY CONTROL  WATER PUMP WITH MOTOR  REMOVAL  


PROCEDURE

Hide 51441 1.REMOVE NO. 1 ENGINE UNDER COVER

Hide G9040 3.REMOVE INVERTER WATER PUMP ASSEMBLY

a.
A371729

Disconnect the inverter water pump assembly connector.

NOTICE:
To prevent coolant from entering the inverter water pump assembly connector, perform the following procedure.

Apply insulating tape to the connectors of the wire harness and inverter water pump assembly.



b.

Remove the 2 bolts.


c.
A371730C04
0.427,0.271 0.646,0.271 0.646,0.271 0.708,0.552 true 2,0.271 2.656,0.271 true 0.229,0.208 0.469,0.417 0.24,0.208 10 true *1 2.677,0.198 2.917,0.406 0.24,0.208 10 true *2
*1 Outlet No. 1 Hybrid Water Pump Hose
*2 Inlet Hybrid Water Pump Hose


Slide the 2 clips and disconnect the outlet No. 1 hybrid water pump hose and inlet hybrid water pump hose to remove the inverter water pump assembly.

NOTICE:
·

Put pieces of cloth into the pipes and disconnected hoses or cover the pipes and hoses with plastic bags to prevent foreign matter from entering the inverter water pump assembly and inverter cooling system.

·

Do not apply excessive force to the hoses.