78110K
1.INSTALL ACCELERATOR PEDAL SENSOR ASSEMBLY (for LHD)
Avoid physical shock to the accelerator pedal sensor assembly.
Do not disassemble the accelerator pedal sensor assembly.
The accelerator pedal sensor assembly does not require lubrication.
Do not apply oil or other lubricants to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.
Type A:
Install the accelerator pedal sensor assembly with the 2 nuts.
If the accelerator pedal sensor assembly has been struck or dropped, replace it.
Connect the accelerator pedal sensor assembly connector.
Type B:
Install the accelerator pedal sensor assembly with the 3 nuts.
If the accelerator pedal sensor assembly has been struck or dropped, replace it.
Connect the accelerator pedal sensor assembly connector.
78110K
2.INSTALL ACCELERATOR PEDAL SENSOR ASSEMBLY (for RHD)
Avoid physical shock to the accelerator pedal sensor assembly.
Do not disassemble the accelerator pedal sensor assembly.
The accelerator pedal sensor assembly does not require lubrication.
Do not apply oil or other lubricants to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.
Install the accelerator pedal sensor assembly with the 2 nuts.
If the accelerator pedal sensor assembly has been struck or dropped, replace it.
Connect the accelerator pedal sensor assembly connector.
55606
3.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
62112
4.INSTALL COWL SIDE TRIM BOARD LH (for LHD)
67914
5.INSTALL FRONT DOOR SCUFF PLATE LH (for LHD)
62111C
6.INSTALL COWL SIDE TRIM BOARD RH (for RHD)
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION
67913
7.INSTALL FRONT DOOR SCUFF PLATE RH (for RHD)
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION