Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › INTELLIGENT CLEARANCE SONAR SYSTEM
RM3210E _56 Audio / Visual / Telematics _047512 PARK ASSIST / MONITORING _0244854 INTELLIGENT CLEARANCE SONAR SYSTEM C

PARK ASSIST / MONITORING  INTELLIGENT CLEARANCE SONAR SYSTEM  U1000  CAN Communication Failure (Message Registry)  


DESCRIPTION

When the clearance warning ECU assembly determines that the CAN communication circuit is malfunctioning during self diagnosis, DTC U1000 is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
U1000 CAN Communication Failure (Message Registry) CAN communication circuit malfunction is detected Clearance warning ECU assembly

PROCEDURE

1.CHECK FOR DTC
a.

Using the GTS, check for DTCs according to the prompts on the screen.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM>DTC CHECK / CLEAR

HINT:

After turning the power switch from off to on (IG), wait 10 seconds or more before checking for DTCs.


Body Electrical > IPA/ICS/Clearance Sonar > Trouble Codes
50001 170

b.

Clear the DTCs according to the screen on the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>DTC CHECK / CLEAR

Body Electrical > IPA/ICS/Clearance Sonar > Clear DTCs
50002 170

c.

Recheck for DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM>DTC CHECK / CLEAR

Body Electrical > IPA/ICS/Clearance Sonar > Trouble Codes
50001 170
OK:

DTC U1000 is not output.


HINT:
·

If DTC U1000 is not output after clearing the DTCs, an intermittent CAN communication circuit malfunction is suspected.

·

If DTC U1000 is output frequently, replace the clearance warning ECU assembly, even though the DTC was not output when rechecking for DTCs.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING



Result:
Proceed to
OK
NG




OK

NG