Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › CLEARANCE WARNING ECU
RM3210E _56 Audio / Visual / Telematics _047512 PARK ASSIST / MONITORING _0243253 CLEARANCE WARNING ECU A

PARK ASSIST / MONITORING  CLEARANCE WARNING ECU  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during clearance warning ECU assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Parking assist monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)
Replacement of clearance warning ECU assembly
·

Ultrasonic sensor detection angle

·

Steering angle neutral point

·

Registration of bumper type

·

Ultrasonic sensor detection angle registration


·

Intelligent clearance sonar system

·

Toyota parking assist-sensor system

·

Simple intelligent parking assist system


(Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>CALIBRATION

CAUTION:
B401522

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


PROCEDURE

Hide 1.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 89343D 2.REMOVE NO. 2 CLEARANCE WARNING BUZZER

Hide 89340A 3.REMOVE CLEARANCE WARNING ECU ASSEMBLY

a.

for LHD:

i.
E342045

Disconnect the connector.


ii.

Remove the bolt.


iii.

Disengage the 2 guides to remove the clearance warning ECU assembly.



b.

for RHD:

i.
E338113

Disconnect the connector.


ii.

Remove the bolt.


iii.

Disengage the 2 guides to remove the clearance warning ECU assembly.