Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › INTELLIGENT CLEARANCE SONAR SYSTEM
RM3210E _56 Audio / Visual / Telematics _047512 PARK ASSIST / MONITORING _0244854 INTELLIGENT CLEARANCE SONAR SYSTEM C

PARK ASSIST / MONITORING  INTELLIGENT CLEARANCE SONAR SYSTEM  C1A40  ENG / EHV Device  


DESCRIPTION

When a hybrid control system malfunction signal sent by the hybrid control ECU is detected by the clearance warning ECU assembly, DTC C1A40 is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1A40 ENG / EHV Device When the power switch is on (IG), a hybrid control system malfunction signal is detected for 1 second or more.
·

Hybrid control system

·

Clearance warning ECU assembly



CAUTION / NOTICE / HINT

NOTICE:
·

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

After replacing an ultrasonic sensor or the clearance warning ECU assembly, perform the necessary procedures (adjustment, calibration, initialization or registration).

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>CALIBRATION



PROCEDURE

1.CHECK DTC OUTPUT
a.

Using the GTS, check for DTCs according to the prompts on the screen.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>DTC CHECK / CLEAR

HINT:

After turning the power switch from off to on (IG), wait 4 seconds or more before checking for DTCs.


Body Electrical > IPA/ICS/Clearance Sonar > Trouble Codes
50001 170

b.

Clear the DTCs according to the screen on the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>DTC CHECK / CLEAR

Body Electrical > IPA/ICS/Clearance Sonar > Clear DTCs
50002 170

c.

Recheck for DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>DTC CHECK / CLEAR

Body Electrical > IPA/ICS/Clearance Sonar > Trouble Codes
50001 170
HINT:
·

DTC C1A40 is stored when a malfunction signal sent from the hybrid control system is detected.

·

If the malfunctioning part has been repaired or replaced before rechecking for DTCs, DTC C1A40 will not be output again.

·

If DTC C1A40 is output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING




Result:
Result Proceed to
DTC C1A40 is output A
DTC C1A40 is not output B



A

B