Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM
RM3210E _56 Audio / Visual / Telematics _047512 PARK ASSIST / MONITORING _0244855 TOYOTA PARKING ASSIST-SENSOR SYSTEM C

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM  U1000  CAN Communication Failure (Message Registry)  


DESCRIPTION

If DTC U1000 is stored frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again even if the DTC is not output when rechecking for DTCs.

DTC No. Detection Item DTC Detection Condition Trouble Area
U1000 CAN Communication Failure (Message Registry) ECU malfunction Clearance warning ECU assembly

PROCEDURE

1.CHECK FOR DTC
a.

Clear the DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM>DTC CHECK / CLEAR

Body Electrical > IPA/ICS/Clearance Sonar > Clear DTCs
50002 170

b.

Check for DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM>DTC CHECK / CLEAR

Body Electrical > IPA/ICS/Clearance Sonar > Trouble Codes
50001 170
OK:

DTC U1000 is not output.


Result:
Proceed to
OK
NG


HINT:
·

If DTC U1000 is not output after clearing the DTCs, an intermittent CAN communication circuit malfunction is suspected.

·

If DTC U1000 is output frequently, replace the clearance warning ECU assembly, even though the DTC was not output when rechecking for DTCs.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING





OK

NG