Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › SIMPLE INTELLIGENT PARKING ASSIST SYSTEM
RM3210E _56 Audio / Visual / Telematics _047512 PARK ASSIST / MONITORING _0244874 SIMPLE INTELLIGENT PARKING ASSIST SYSTEM C

PARK ASSIST / MONITORING  SIMPLE INTELLIGENT PARKING ASSIST SYSTEM  C164A  EPS Communication Malfunction  


DESCRIPTION

This DTC is stored when the clearance warning ECU assembly receives a communication malfunction signal from the power steering ECU assembly via CAN communication.

DTC No. Detection Item DTC Detection Condition Trouble Area
C164A EPS Communication Malfunction EPS communication malfunction
·

Power steering system

·

Power steering ECU assembly

·

Clearance warning ECU assembly



CAUTION / NOTICE / HINT

NOTICE:

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the simple intelligent parking assist system may be needed.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIMPLE INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION


PROCEDURE

1.CHECK DTC OUTPUT
a.

Clear the DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIMPLE INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR

Body Electrical > IPA/ICS/Clearance Sonar > Clear DTCs
50002 170

b.

Recheck for DTCs and check if the same DTC is output again.

Body Electrical > IPA/ICS/Clearance Sonar > Trouble Codes
50001 170
OK:

No DTCs are output.


HINT:
·

If the DTC is not output again when rechecking for DTCs, it may have been stored due to a temporary communication problem between the clearance warning ECU assembly and power steering ECU assembly.

·

If DTC C164A is output frequently, duplicate the conditions that caused the problem symptoms and perform the inspection again, even though DTCs were not output when rechecking for DTCs.




Result:
Proceed to
OK
NG



OK

NG

2.REPLACE CLEARANCE WARNING ECU ASSEMBLY
2.REPLACE CLEARANCE WARNING ECU ASSEMBLY
a.

Replace the clearance warning ECU assembly.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>CLEARANCE WARNING ECU>REMOVAL


Result:
Proceed to
NEXT



NEXT

3.CHECK DTC OUTPUT
3.CHECK DTC OUTPUT
a.

Clear the DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIMPLE INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR

Body Electrical > IPA/ICS/Clearance Sonar > Clear DTCs
50002 170

b.

Recheck for DTCs and check if the same DTC is output again.

Body Electrical > IPA/ICS/Clearance Sonar > Trouble Codes
50001 170
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

END (CLEARANCE WARNING ECU ASSEMBLY WAS DEFECTIVE)

NG

4.CHECK DTC OUTPUT (POWER STEERING SYSTEM)
4.CHECK DTC OUTPUT (POWER STEERING SYSTEM)
a.

Check for DTCs.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING

Chassis > EMPS > Trouble Codes
50001 142
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

REPLACE POWER STEERING ECU ASSEMBLY

NG