Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM
RM3210E _56 Audio / Visual / Telematics _047512 PARK ASSIST / MONITORING _0244875 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  C1A47  Steering Angle Sensor  


DESCRIPTION

The blind spot monitor sensor receives steering angle signals from the steering sensor via CAN communication.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1A47 Steering Angle Sensor A fail flag is transmitted from the spiral with sensor cable sub-assembly
·

Steering sensor

·

Blind spot monitor sensor LH

·

Blind spot monitor sensor RH



CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor system is turned on.


PROCEDURE

1.CHECK DTC
a.

Turn the power switch off.


b.

Turn the power switch on (IG).


c.

Recheck for DTCs and check if the same DTC is output again.

Body Electrical > Blind Spot Monitor Master > Trouble Codes
50001 313
Body Electrical > Blind Spot Monitor Slave > Trouble Codes
50001 314
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

NG

2.REPLACE STEERING SENSOR
2.REPLACE STEERING SENSOR

Result:
Proceed to
NEXT



NEXT

3.RECHECK DTC
3.RECHECK DTC
a.

Turn the power switch off.


b.

Turn the power switch on (IG).


c.

Recheck for DTCs and check if the same DTC is output again.

Body Electrical > Blind Spot Monitor Master > Trouble Codes
50001 313
Body Electrical > Blind Spot Monitor Slave > Trouble Codes
50001 314

Result:
Result Proceed to
No DTCs are output. A
DTC C1A47 is output ("Blind Spot Monitor Master"). B
DTC C1A47 is output ("Blind Spot Monitor Slave"). C



A

END (STEERING SENSOR WAS DEFECTIVE)

B

C