Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SENSOR
RM3210E _56 Audio / Visual / Telematics _047512 PARK ASSIST / MONITORING _0243259 BLIND SPOT MONITOR SENSOR A

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during blind spot monitor sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Replacement of blind spot monitor sensor Blind Spot Monitor Beam Axis Adjustment DTCs are output (Click here)
Rear bumper assembly (w/ Intelligent clearance sonar system)
·

Ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


·

Intelligent clearance sonar system

·

Simple advanced parking guidance system


(Click here)

PROCEDURE

Hide 1.REMOVE REAR BUMPER ASSEMBLY

Hide 88172 2.REMOVE BLIND SPOT MONITOR SENSOR LH

a.
E338250

Disconnect the connector.


b.

Remove the 3 nuts and blind spot monitor sensor LH.

NOTICE:

Replace the blind spot monitor sensor if it has been dropped or subjected to a severe impact.



Hide 88162 3.REMOVE BLIND SPOT MONITOR SENSOR RH

a.
E338249

Disconnect the connector.


b.

Remove the 3 nuts and blind spot monitor sensor RH.

NOTICE:

Replace the blind spot monitor sensor if it has been dropped or subjected to a severe impact.