This DTC is stored when the blind spot monitor sensor LH detects an internal malfunction.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AB6 | Blind Spot Monitor Master Module | The blind spot monitor sensor LH (master) detects an internal malfunction | Blind spot monitor sensor LH |
When checking for DTCs, make sure that the blind spot monitor system is turned on.
Turn the power switch off.
Turn the power switch on (IG).
Recheck for DTCs and check if the same DTC is output again.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG