Home › Power Source / Network › 2ZR-FXE BATTERY / CHARGING › BATTERY CURRENT SENSOR
RM3210E _57 Power Source / Network _047502 2ZR-FXE BATTERY / CHARGING _0244885 BATTERY CURRENT SENSOR A

2ZR-FXE BATTERY / CHARGING  BATTERY CURRENT SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during battery state sensor assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Parking assist monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>CALIBRATION

PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 28850C 2.REMOVE BATTERY STATE SENSOR ASSEMBLY

a.
A373689

Disengage the 2 claws and disconnect the wire harness from the battery current sensor holder.


b.

Disconnect the battery state sensor assembly connector.


c.
A373690

Remove the nut and disconnect the engine wire from the battery state sensor assembly.

NOTICE:

When disconnecting the engine wire, some systems need to be initialized after the engine wire is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION



d.
A373691

Loosen the nut and remove the battery state sensor assembly from the auxiliary battery.


e.
A373692

Disengage the 2 claws to remove the battery state sensor assembly from the battery current sensor holder.