Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM(for Navigation Receiver Type)
RM3210E _56 Audio / Visual / Telematics _047511 NAVIGATION / MULTI INFO DISPLAY _0245074 NAVIGATION SYSTEM(for Navigation Receiver Type) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for Navigation Receiver Type)  Display Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter  


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the display signal from an external device to the navigation receiver assembly via this circuit.

WIRING DIAGRAM

E268447E50
0.969,0.635 1.427,0.833 0.458,0.198 10 false VV+ 1,1.438 1.458,1.635 0.458,0.198 10 false VV- 1.344,0.542 1.802,0.74 0.458,0.198 10 false 6 1.333,1.323 1.792,1.521 0.458,0.198 10 false 11 0.375,2.677 0.833,2.875 0.458,0.198 10 false F38 0.375,2.875 1.708,3.25 1.333,0.375 10 false No. 1 Stereo Jack Adapter Assembly 3.271,1.75 4.031,1.938 0.76,0.188 10 false (Shielded) 5.667,0.542 6.125,0.74 0.458,0.198 10 false 13 5.677,1.323 6.135,1.521 0.458,0.198 10 false 14 5.677,2.104 6.135,2.302 0.458,0.198 10 false 12 5.906,0.635 6.365,0.833 0.458,0.198 10 false VV+ 5.906,1.438 6.365,1.635 0.458,0.198 10 false VV- 5.906,2.219 6.365,2.417 0.458,0.198 10 false SG 5.708,2.656 6.167,2.854 0.458,0.198 10 false F92 5.708,2.833 6.906,3.219 1.198,0.385 10 false Navigation Receiver Assembly

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.

Disconnect the F92 navigation receiver assembly connector.


b.

Disconnect the F38 No. 1 stereo jack adapter assembly connector.


c.
E277839C43
1.5,0.333 1.917,0.552 0.417,0.219 1.5,2.281 1.917,2.5 0.417,0.219 2.302,1.396 2.656,0.99 false 2.198,1.396 2.594,0.667 false 2.75,1.333 2.406,1.406 false 1.083,3.583 1.448,3.792 false 1.083,4.083 1.438,3.948 false 0.167,0.135 0.479,0.333 0.313,0.198 10 false *a 0.188,2.333 0.5,2.531 0.313,0.198 10 false *b 1.594,0.365 2.052,0.563 0.458,0.198 10 false F92 1.604,2.313 2.063,2.51 0.458,0.198 10 false F38 2.708,0.885 3.167,1.083 0.458,0.198 10 false VV+ 2.625,0.5 3.083,0.698 0.458,0.198 10 false SG 2.792,1.219 3.25,1.417 0.458,0.198 10 false VV- 0.792,3.417 1.25,3.615 0.458,0.198 10 false VV+ 0.833,4.083 1.292,4.281 0.458,0.198 10 false VV-
*a Front view of wire harness connector
(to Navigation Receiver Assembly)
*b Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F92-13 (VV+) - F38-6 (VV+) Always Below 1 Ω
F92-14 (VV-) - F38-11 (VV-) Always Below 1 Ω
F92-13 (VV+) or F38-6 (VV+) - Body ground Always 10 kΩ or higher
F92-14 (VV-) or F38-11 (VV-) - Body ground Always 10 kΩ or higher
F92-12 (SG) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR