The power window regulator motor assemblies are operated by the multiplex network master switch assembly, power window regulator switch assembly or rear power window regulator switch assemblies. The power window regulator motor assembly has motor, regulator and ECU functions.
When the ECU built into a power window regulator motor assembly determines that the power window regulator motor assembly has not been initialized, DTC B2313 is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2313 | Glass Position Initialization Incomplete | ·
Power window regulator motor assembly (for driver door) not initialized ·
Power window regulator motor assembly (for driver door) is malfunctioning ·
Auxiliary battery disconnected when power switch on (IG) |
·
Power window regulator motor assembly (for driver door) not initialized ·
Power window regulator motor assembly (for driver door) |
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2313 | Glass Position Initialization Incomplete | ·
Power window regulator motor assembly (for front passenger door) not initialized ·
Power window regulator motor assembly (for front passenger door) is malfunctioning ·
Auxiliary battery disconnected when power switch on (IG) |
·
Power window regulator motor assembly (for front passenger door) not initialized ·
Power window regulator motor assembly (for front passenger door) |
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2313 | Glass Position Initialization Incomplete | ·
Power window regulator motor assembly (for rear LH door) not initialized ·
Power window regulator motor assembly (for rear LH door) is malfunctioning ·
Auxiliary battery disconnected when power switch on (IG) |
·
Power window regulator motor assembly (for rear LH door) not initialized ·
Power window regulator motor assembly (for rear LH door) |
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2313 | Glass Position Initialization Incomplete | ·
Power window regulator motor assembly (for rear RH door) not initialized ·
Power window regulator motor assembly (for rear RH door) is malfunctioning ·
Auxiliary battery disconnected when power switch on (IG) |
·
Power window regulator motor assembly (for rear RH door) not initialized ·
Power window regulator motor assembly (for rear RH door) |
DTC B2313 is stored in each power window regulator motor assembly.
If the auxiliary battery is disconnected while the power switch is on (IG), DTC B2313 will be stored.
If a power window regulator motor assembly has been replaced with a new one, initialize the power window control system.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION
Turn the power switch on (IG).
Initialize the power window regulator motor assembly.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION
Initialize the power window regulator motor assembly that has DTC B2313 stored in its ECU.
| Proceed to |
|---|
| NEXT |
NEXT
Turn the power switch off.
Wait for at least 10 seconds, and then turn the power switch on (IG).
Check for DTCs.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>DTC CHECK / CLEAR
Check for DTCs for the power window regulator motor assembly that had DTC B2313 stored in its ECU.
DTC B2313 is not output.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (Driver door power window) | B |
| NG (Front passenger door power window) | |
| NG (Rear LH door power window) | C |
| NG (Rear RH door power window) |
A
B
C