The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during power window regulator motor removal/installation are shown below.
*1: When performing learning using the GTS.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>CALIBRATION
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
69284G
3.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG
74260
4.REMOVE REAR ARMREST ASSEMBLY
5.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL
67604
6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
7.REMOVE REAR DOOR INNER GLASS WEATHERSTRIP WITH REAR DOOR NO. 2 VENT SEAL
67842E
8.REMOVE REAR DOOR SERVICE HOLE COVER
67858B
9.REMOVE REAR DOOR PANEL PROTECTOR
67844A
10.REMOVE REAR DOOR NO. 2 SERVICE HOLE COVER
68152C
11.REMOVE REAR DOOR GLASS RUN
67872
12.DISCONNECT REAR DOOR WEATHERSTRIP
67408E
13.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY
68124B
14.REMOVE REAR DOOR QUARTER WINDOW GLASS
68104
15.REMOVE REAR DOOR GLASS SUB-ASSEMBLY
16.REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY
85720E
17.REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY
Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly.