Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM
RM3210E _54 Brake _047516 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0245157 ELECTRONICALLY CONTROLLED BRAKE SYSTEM J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM  Brake Actuator Operation Sound is Loud during Initial Check  


CAUTION / NOTICE / HINT

NOTICE:

After replacing the brake actuator assembly, perform linear solenoid valve offset learning, ABS holding solenoid valve learning, yaw rate and acceleration sensor zero point calibration and system information memorization after performing "Reset Memory".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>INITIALIZATION


PROCEDURE

1.PERFORM ROAD TEST
a.

After turning the power switch on (READY), compare the operating sound of the brake actuator the first time the vehicle speed reaches approximately 25 km/h (16 mph) with a known good vehicle of the same model.

OK:

The operating sound is the same or quieter than that of a known good vehicle of the same model.


HINT:

When the vehicle speed reaches approximately 20 km/h (12 mph), the initial check of the brake actuator assembly is performed and pump motor operation sounds are generated.



Result:
Proceed to
OK
NG



OK

END

NG

2.CHECK BRAKE ACTUATOR BOLT CUSHION
2.CHECK BRAKE ACTUATOR BOLT CUSHION
a.

Check that the cushion of the brake actuator bracket assembly is not worn, damaged or deformed.

OK:

The brake actuator bracket assembly is not worn, damaged or deformed.



Result:
Proceed to
OK
NG



OK

3.ADJUST INSTALLATION OF BRAKE ACTUATOR ASSEMBLY

NG

REPLACE BRAKE ACTUATOR BOLT CUSHION

3.ADJUST INSTALLATION OF BRAKE ACTUATOR ASSEMBLY
a.

Drain the brake fluid.


b.

c.

Connect each brake line so that the cushion of the brake actuator assembly is tensioned evenly.

for LHD: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR(for LHD)>INSTALLATION

for RHD: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR(for RHD)>INSTALLATION

NOTICE:

After connecting all the brake lines, add brake fluid and bleed the brake system.

Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID>BLEEDING


HINT:

By reducing the tension on the brake lines and cushion, the operating sound of the brake actuator assembly may be reduced.



d.

Check that no brake lines interfere the vehicle body or other components.


Result:
Proceed to
NEXT



NEXT

4.RECHECK SYMPTOM
4.RECHECK SYMPTOM
a.

Perform a road test and check the magnitude of the operating sound again.

OK:

The operating sound is the same or quieter than that of a known good vehicle of the same model.



Result:
Proceed to
OK
NG



OK

END

NG