The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during mobile phone battery removal/installation are shown below.
1. PRECAUTION
86741A
2.REMOVE TELEMATICS TRANSCEIVER
86725
3.REMOVE MOBILE PHONE BATTERY
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Loosen the 2 screws.
The 2 screws cannot be removed because they are integrated into the battery cover sub-assembly.
Disengage the 2 claws and 3 guides as shown in the illustration to remove the battery cover sub-assembly.
Lift the battery, disconnect the connector and remove the battery as shown in the illustration.
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |