Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS TRANSCEIVER › from 2016.08
RM3210E _56 Audio / Visual / Telematics _057161 TELEMATICS _0279442 TELEMATICS TRANSCEIVER A

TELEMATICS  TELEMATICS TRANSCEIVER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during telematics transceiver removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Replacement of telematics transceiver Register vehicle information Emergency call service (Click here)

PROCEDURE

Hide 55435A 1.REMOVE INSTRUMENT PANEL FINISH PANEL END RH

Hide 55405B 2.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 3.REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET

Hide 4.REMOVE TELEMATICS TRANSCEIVER WITH ANTENNA CORD

a.
E351455

Disconnect the connector.


b.
E351456

Remove the 2 nuts.


c.
E351457

Disconnect the connector and remove the telematics transceiver with antenna cord.


Hide 86101S 5.REMOVE ANTENNA CORD SUB-ASSEMBLY

a.
E351458

Disengage the claw.


b.

Disconnect the 2 connectors to remove the antenna cord sub-assembly.


Hide 86741A 6.REMOVE TELEMATICS TRANSCEIVER