If any of the following conditions are detected, the ABS warning light remains on:
The ECU connectors are disconnected from the skid control ECU.
There is a malfunction in the skid control ECU internal circuit.
There is an open or short in the wire harness between the combination meter and the skid control ECU.
HINT:
The intelligent tester may not be used when there is a malfunction in the skid control ECU.
WIRING DIAGRAM
INSPECTION PROCEDURE
1. CHECK CAN COMMUNICATION SYSTEM
Check if the CAN communication system DTC is output (Click here).
Result
Result
Proceed to
DTC is not output
A
DTC is output
B
B
REPAIR CAN COMMUNICATION SYSTEM
A
2. INSPECT SKID CONTROL ECU CONNECTOR
Check if the skid control ECU connector is properly installed.
OK:
The skid control ECU connector is properly installed.
NG
CONNECT CONNECTOR TO ECU SECURELY
OK
3. CHECK WIRE HARNESS (SKID CONTROL ECU - BATTERY AND BODY GROUND)
Disconnect the A26 ECU connector.
Measure the resistance of the wire harness side connector.
Standard resistance:
Tester Connection
Specified Condition
A26-32 (GND1) - Body ground
Below 1 Ω
A26-1 (GND2) - Body ground
Below 1 Ω
Measure the voltage of the wire harness side connector.
Standard voltage:
Tester Connection
Condition
Specified Condition
A26-46 (IG1) - Body ground
Ignition switch on (IG)
10 to 14 V
NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK
4. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (ABS WARNING LIGHT)
Select the Active Test, generate a control command, and then check that the ABS warning light operates.
Skid control ECU
Item (Display)
Test Details
Diagnostic Notes
ABS Warning Lamp
Turns ABS warning light / ON or OFF
Observe combination meter
OK:
The ABS warning light is turned on or off.
HINT:
When the ABS warning light remains illuminated, opens in the wire harness of the combination meters or abnormalities in the meter circuit should be considered.