2005-2008 RAV4 · Service Manual BRAKE

TC and CG Terminal Circuit

Circuit diagnosis · Vehicles built Jan 2007 – Jul 2007

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008 from Aug 2008

DESCRIPTION

Connecting terminals TC and CG of the DLC3 causes the skid control ECU to display 2-digit DTCs by flashing the ABS warning light.

WIRING DIAGRAM

C118698E01

INSPECTION PROCEDURE


1. CHECK DLC3 (TC VOLTAGE)

  1. C108847E36
    Turn the ignition switch on (IG).

  1. Measure the voltage of the DLC3.

    Standard voltage:
    Tester Connection
    Specified Condition
    E16-13 (TC) - Body ground
    10 to 14 V



NG
Go to step 3
OK


2. CHECK CAN COMMUNICATION SYSTEM
  1. Check the DTC (Click here).

Result 
Result
Proceed to
DTC is not output
A
DTC is output
B


B
REPAIR CIRCUIT INDICATED BY OUTPUT DTC
A

REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY

3. CHECK WIRE HARNESS (DLC3 - ECM)
C161673E01
  1. Turn the ignition switch off.

  1. Disconnect the A12 ECM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E16-13 (TC) - A12-27 (TC)*1
    Below 1 Ω
    E16-13 (TC) - A12-26 (TC)*2
    Below 1 Ω
    A12-27 (TC)*1 - Body ground
    10 kΩ or higher
    A12-26 (TC)*2 - Body ground
    10 kΩ or higher

    HINT:
    *1: for 2AZ-FE, 1AZ-FE
    *2: for 2AD-FHV, 2AD-FTV



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


4. CHECK WIRE HARNESS (DLC3 - BODY GROUND)

  1. H100769E38
    Measure the resistance of the DLC3.

    Standard resistance:
    Tester Connection
    Specified Condition
    E16-4 (CG) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


5. CHECK CAN COMMUNICATION SYSTEM
  1. Check if the CAN communication DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
REPAIR CIRCUIT INDICATED BY OUTPUT DTC
A

REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY


← TC and CG Terminal Circuit (Nov 2005 – Dec 2006)TC and CG Terminal Circuit (Aug 2007 – Jul 2008) →