2005-2008 RAV4 · Service Manual BRAKE

TC and CG Terminal Circuit

Circuit diagnosis · Vehicles built from Aug 2008

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008 from Aug 2008

DESCRIPTION

Connecting terminals 13 (TC) and 4 (CG) of the DLC3 causes the skid control ECU to output 2-digit DTCs by flashing the ABS warning light/slip indicator light.

WIRING DIAGRAM

C194153E03

INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform zero point calibration (Click here).


1. CHECK DLC3 (TC VOLTAGE)

  1. C108847E50
    Turn the ignition switch to ON.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    E16-13 (TC) - Body ground
    Ignition switch ON
    11 to 14 V



NG
Go to step 3
OK


2. CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).

Result:
Result
Proceed to
DTC is not output.
A
DTC is output.
B



B
REPAIR CIRCUIT INDICATED BY OUTPUT DTC (Click here)
A

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)

3. CHECK HARNESS AND CONNECTOR (DLC3 - ECM)

  1. C126294E15
    Turn the ignition switch off.

  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E16-13 (TC) - A12-27 (TC)
    Always
    Below 1 Ω
    A12-27 (TC) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)

  1. C108847E51
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E16-4 (CG) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5. CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).

    Result:
    Result
    Proceed to
    DTC is not output.
    A
    DTC is output.
    B



B
REPAIR CIRCUIT INDICATED BY OUTPUT DTC (Click here)
A

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)


← TC and CG Terminal Circuit (Aug 2007 – Jul 2008)TS and CG Terminal Circuit (Nov 2005 – Jul 2008) →