2005-2008 RAV4 · Service Manual ENGINE

FREEZE FRAME DATA

Troubleshooting · Vehicles built from Jan 2007


DESCRIPTION
  1. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame date can be helpful in determining whether the vehicle was running or stopped, whether the air-fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.

    HINT:
    If it is impossible to duplicate the problem even though a DTC is detected, confirm the freeze frame data.


  1. A103809E18
    The ECM records engine conditions in the form of freeze frame data every 0.5 seconds. Using an intelligent tester, 5 separate sets of freeze frame data can be checked.
    1. 3 data sets before the DTC was set.
    2. 1 data set when the DTC was set.
    3. 1 data set after the DTC was set.
    1. These data sets can be used to simulate the condition of the vehicle around the time of the occurrence of the malfunction. The data may assist in identifying the cause of the malfunction, and in judging whether it was temporary or not.

LIST OF FREEZE FRAME DATA
LABEL
(Tester Display)
Measurement Item/Range
Diagnostic Note
Trouble Code
Freeze DTC
-
Calculate Load
Calculated load
Calculated load by ECM
MAF
Mass air flow volume
If approximately 0.0 g/sec.:
  1. Mass air flow meter power source circuit is open or shorted
  1. VG circuit is open or shorted
If 160.0 g/sec. or more:
  1. E2G circuit is open
MAP
Absolute pressure inside intake manifold
-
Engine Speed
Engine speed
-
Vehicle Speed
Vehicle speed
Speed indicated on speedometer
Coolant Temp
Engine coolant temperature
If -40°C (-40°F), sensor circuit is open
If 140°C (284°F) or more, sensor circuit is shorted
Intake Air
Intake air temperature
If -40°C (-40°F), sensor circuit is open
If 140°C (284°F) or more, sensor circuit is shorted
Fuel Press
Fuel pressure
-
EGR Position
EGR position
-
Accelerator Position No.1
Absolute accelerator pedal position No. 1
-
Accelerator Position No.2
Absolute accelerator pedal position No. 2
-
Throttle Position
Throttle position
-
Throttle Motor
Throttle actuator
-
AFS B1 S1
Air fuel ratio sensor output
Performing control the injection volume or control the injection volume for air fuel ratio sensor function of active test enables technician to check output voltage of sensor
AF FT B1 S1
Fuel trim at air fuel ratio sensor
-
Initial Engine Coolant Temp
Engine coolant temperature at engine start
-
Initial Intake Air Temp
Intake air temperature at engine start
-
Initial Exhaust Temp (In)
Exhaust temperature sensor for IN
-
Initial Exhaust Temp (Out)
Exhaust temperature sensor for OUT
-
Intake Air Temp (Turbo)
Intake air temperature (Turbo)
-
DPF Differential Pressure
DPF differential pressure
-
EGR Lift Position
EGR lift position
-
EGR Close Learning Value
EGR close learning value
-
Accel Position
Accelerator pedal position sensor
-
Fuel Temperature
Fuel temperature
-
VNT Command
VN turbo command
-
Pump VCM Angle
Pump VCM angle
-
IDL Stable Control
Idle stable control
-
Diesel Throttle Angle
Diesel throttle angle
-
Pilot 1 Injection
Pilot 1 injection
-
Pilot 2 Injection
Pilot 2 injection
-
Main Injection
Main injection
-
After Injection
After injection
-
Pilot 1 Injection
Pilot 1 injection
-
Pilot 2 Injection
Pilot 2 injection
-
Main Injection
Main injection
-
After Injection
After injection
-
Injection Feedback Value
Injection volume feedback learning value
-
Injection Feedback Val #1
Injection volume correction for cylinder 1
-
Injection Feedback Val #2
Injection volume correction for cylinder 2
-
Injection Feedback Val #3
Injection volume correction for cylinder 3
-
Injection Feedback Val #4
Injection volume correction for cylinder 4
-
Injection Volume
Injection volume
-
DPF Catalyst Deteriorate
DPF catalyst deteriorate
-
DPF No Activate
DPF operation
-
DPF PM Block
DPF PM block
-
Injector Memory Error
EEPROM malfunction for injector
-
Catalyst Memory Error
EEPROM malfunction for catalyst
-
Diesel Throttle Lean Status
Diesel throttle leaning status
-
EGR Leaning Status
EGR leaning status
-
ACC Relay
ACC relay
-
Starter Relay
Starter relay
-
Starter Signal
Starter switch (STSW) signal
-
Starter Control
Starter control
-
A/C Signal
Air conditioning signal
-
Neutral Position SW Signal
Park/Neutral position switch signal
-
Stop Light Switch
Stop light switch
-
Battery Voltage
Battery voltage
-
Atmosphere Pressure
Atmosphere pressure
-
Battery Current
Battery current
Charging control service data
Battery Temperature
Battery temperature
Charging control service data
Alternator Output Duty
Generator output duty
Electricity generated by alternator is output through duty ratio
Charging control service data
Alt Vol - Non Active Test
Request voltage when regulator not under forced activation
Alternator regulator output voltage is output
When performing Active Test, value is OV.
Alt Vol - Active Test
Request voltage when regulator under forced activation
Charging control service data
When performing Active Test, value is OV.
Electric Fan Motor
Electric fan motor
-
TC and TE1
TC and TE1 terminals of DLC3
-
Engine Run Time
Accumulated engine running time
-
Time after DTC Cleared
Cumulative time after DTC cleared
-
Distance from DTC Cleared
Accumulated distance after DTC cleared
-
Warmup Cycle Cleared DTC
Warm-up cycle after DTC cleared
-
← DTC CHECK / CLEAR (from Aug 2007)CHECK MODE PROCEDURE (from Jan 2007) →