2005-2008 RAV4 · Service Manual ENGINE

DTC CHECK / CLEAR

Troubleshooting · Vehicles built from Aug 2007

Versions by build date: Jan 2007 – Jul 2007 from Aug 2007

NOTICE:
When the diagnosis system is changed from normal mode to check mode or vice versa, all DTCs and freeze frame data that were recorded in normal mode are erased. Before changing modes, always check and make a note of any DTCs and freeze frame data.

HINT:
  1. DTCs which are stored in the ECM can be displayed on the intelligent tester. The intelligent tester can display both current and pending DTCs.
  2. Malfunctions that were not detected a second time by the ECM during the second driving cycle are stored as pending DTCs.


CHECK FOR DTC
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG) and turn the tester on.

  3. Select the following menu items: Powertrain / Engine and ECT / DTC.

  4. Check DTC(s) and freeze frame data, and then write them down.

  5. Check the details of the DTC(s) (Click here).


CLEAR DTC
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG) and turn the tester on.

  3. Select the following menu items: Powertrain / Engine and ECT / DTC / Clear.

  4. Press the YES button.

← DTC CHECK / CLEAR (Jan 2007 – Jul 2007)FREEZE FRAME DATA (from Jan 2007) →