2005-2008 RAV4 · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built Nov 2005 – Dec 2006

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007


CHECK FUEL PUMP OPERATION

  1. B127990E01
    Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG). Do not start the engine.

  1. Select the following tester menus: POWERTRAIN / ENGINE / ACTIVE TEST / FUEL / PUMP / SPEED. Operate the fuel pump.

  1. Touch the fuel hose in the engine compartment to check the fuel flow, and you will also be able to hear the sound of the fuel pump.

  1. Stop the fuel pump.
    If there is no fuel flow, the fuel pump may not operate. Check the fuel pump circuit (Click here).


CHECK FUEL PRESSURE
  1. Check that the battery positive voltage is above 12 V.

  1. Discharge the fuel system pressure (Click here).

  1. Disconnect the cable from the negative (-) battery terminal.

  1. Disconnect the fuel main tube (Click here).

  1. A088229E05
    Install SST (pressure gauge) as shown in the illustration.
    SST
    09268-31011   (95336-08070, 90467-13001, 09268-41500)
    09268-45014   (09268-41200, 09268-41220, 09268-41250)

  1. Wipe off any gasoline.

  1. Reconnect the cable to the negative (-) battery terminal.

  1. Start the engine.

  1. Measure the fuel pressure at idle.

    Fuel pressure:
    304 to 343 kPa (3.1 to 3.5 kgf/cm2, 44 to 50 psi)

    If the pressure is not as specified, check the fuel pump and injectors.

  1. After checking the fuel pressure, disconnect the cable from the negative (-) battery terminal and carefully remove SST and the fuel tube connector to prevent fuel from spilling.

  1. Reconnect the fuel main tube (Click here).

  1. Check for fuel leaks (Click here).

← SYSTEM DIAGRAM (from Nov 2005)ON-VEHICLE INSPECTION (Jan 2007 – Jul 2007) →