2005-2008 RAV4 · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Nov 2005


1. INSTALL FAN AND GENERATOR V BELT

  1. A123517E02
    Using SST and 22 mm wrench, rotate the tensioner pulley counterclockwise, and then install the V-ribbed belt.
    SST
    09216-42010  

    NOTICE:
    1. Make sure that the V-ribbed belt is set properly at each pulley.
    2. Make sure SST is installed as shown in the illustration. If not, SST and/or the V-ribbed belt may not be able to be removed.


2. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH

A129514E01
  1. Install the reinforcement with the 4 bolts.

    Torque:
    95 N*m{ 969 kgf*cm , 70 ft.*lbf }


3. INSTALL ENGINE UNDER COVER RH
  1. Install the engine under cover with the 2 clips.


4. INSTALL NO. 1 ENGINE UNDER COVER
  1. Install the engine under cover with the 12 clips and 4 bolts.


5. CONNECT RADIATOR RESERVE TANK

  1. A124931
    Install the reserve tank bracket with the bolt.

  1. A124930
    Connect the reserve tank with the 2 bolts.


6. INSTALL NO. 1 ENGINE COVER

  1. A123518
    Attach the 4 clips to install the engine cover.

← REMOVAL (from Nov 2005)COMPONENTS (from Nov 2005) →