REMOVAL
Removal / installation · Vehicles built from Nov 2005
| 1.
REMOVE NO. 1 ENGINE COVER |
 |
- Detach the 4 clips and remove the engine cover.
| 2.
DISCONNECT RADIATOR RESERVE TANK |
 |
- Disconnect the 2 bolts and reserve tank.
- Remove the bolt and reserve tank bracket.
| 3.
REMOVE NO. 1 ENGINE UNDER COVER |
 |
Remove the 4 bolts, 12 clips and engine under cover.
| 4.
REMOVE ENGINE UNDER COVER RH |
 |
Remove the 2 clips and engine under cover.
| 5.
REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH |
 |
Remove the 4 bolts and reinforcement.
| 6.
REMOVE FAN AND GENERATOR V BELT |
 |
- Using SST and 22 mm wrench, rotate the tensioner pulley counterclockwise to loosen the belt tension. Then remove the V-ribbed belt.
- SST
- 09216-42010
- NOTICE:
- Make sure SST is installed as shown in the illustration. If not, SST and/or the V-ribbed belt may not be able to be removed.