2005-2008 RAV4 · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Aug 2007


1. INSTALL V-RIBBED BELT

  1. A137895
    Rotate the tensioner pulley counterclockwise, and then install the V-ribbed belt.

  1. A139509E01
    If it is difficult to install the V-ribbed belt, perform the following procedure.

    1. Put the V-ribbed belt on everything except the tensioner pulley as shown in the illustration.

    2. While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the tensioner pulley.

      NOTICE:
      1. Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
      2. Check that the V-ribbed belt is properly set to each pulley.


2. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH

  1. A129514E01
    Install the reinforcement with the 4 bolts.

    Torque:
    96 N*m{ 978 kgf*cm , 71 ft.*lbf }


3. INSTALL REAR ENGINE UNDER COVER RH
  1. Install the under cover with the 2 clips.


4. INSTALL NO. 1 ENGINE UNDER COVER
  1. Install the under cover with the 2 bolts, 4 screw and 12 clips.


5. CONNECT RADIATOR RESERVOIR TANK ASSEMBLY

  1. A178054
    Connect the reservoir tank with the 2 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }


6. INSTALL V-BANK COVER SUB-ASSEMBLY

  1. A137900
    Attach the 3 clips to install the engine cover.


7. INSTALL RADIATOR SUPPORT OPENING COVER

  1. A137899
    Install the cover with the 9 clips.

← REMOVAL (from Aug 2007)COMPONENTS (from Aug 2007) →