2005-2008 RAV4 · Service Manual ENGINE

PRECAUTION

Precautions · Vehicles built Jan 2007 – Jul 2007

Versions by build date: Jan 2007 – Jul 2007 from Aug 2007


NOTICE:
Replace the ECM, DPF catalyst and/or injector after the following operations:
Replacement part
Operation
ECM
Input injector compensation code (Click here) and transfer DPF thermal deterioration data (Click here)
DPF catalyst
Clear DPF thermal deterioration data (Click here)
Injector
Input injector compensation code (Click here)
ECM and DPF catalyst
Input injector compensation code (Click here) and clear DPF thermal deterioration data (Click here)


1.CATALYST RECORD OF DPF THERMAL DETERIORATION

HINT:
The ECM stores the history data of DPF catalyst thermal deterioration. This data is updated continuously and is then converted to 8-digit code and is stored in the EEPROM. If the ECM determines that replacement of the DPF catalyst is required based on the thermal deterioration data, the DTC is set to inform the driver.

  1. When only the DPF catalyst is replaced.

    1. After replacing the DPF catalyst, clear the thermal deterioration data stored in the ECM (Click here).

  2. When only the ECM is replaced.

    1. After replacing the ECM, input the original thermal deterioration data stored before replacement (Click here).

      NOTICE:
      1. Read the thermal deterioration data stored in the ECM before replacement, and store the data in the intelligent tester.
      2. If the thermal deterioration data cannot be read, be sure to replace the DPF catalyst with a new one and initialize the ECM (Click here).

  3. After replacing both the DPF catalyst and the ECM, clear the thermal deterioration data stored in the new ECM (Click here).

    HINT:
    Clearing the thermal codes is required because initialization codes are stored in a new ECM. Failure to do this will cause a DTC to be set.


2.INJECTOR COMPENSATION CODE

HINT:
  1. Each injector has different fuel injection characteristics. In order to optimize fuel injection performance, the ECM compensates for these differences by adjusting the fuel injection duration of each injector according to its compensation code. Injector compensation codes are unique, 30-digit, alphanumeric values printed on the head portion of each injector.
  2. If an incorrect injector compensation code is input into the ECM, the engine may rattle or engine idling may become rough. In addition, engine failure may occur and the life of the engine may be shortened.

  1. A156012E01
    When an injector is replaced, the injector's compensation code must be input into the ECM (Click here).

  2. When the ECM is changed, all of the existing injector compensation codes must be input into the new ECM (Click here).


3.DIFFICULT TO START ENGINE, ENGINE STALLING, OR BLACK SMOKE EMITTED
  1. Check if the customer's problem is described below. If so, refer to the troubleshooting section on the page given.

    1. Engine is difficult to start or stalls (Click here).

    2. Black smoke is emitted (Click here).


4.FOR USING INTELLIGENT TESTER

CAUTION:
  1. Observe the following items for safety reasons:
    1. Before using the tester, read its instruction manual.
    2. Prevent the tester cable from being caught on the pedals, shift lever or steering wheel when driving with the tester connected to the vehicle.
    3. When driving the vehicle for testing purposes using the tester, two persons are required. One is for driving the vehicle, and the other operates the tester.

← MIL Circuit (from Aug 2007)PRECAUTION (from Aug 2007) →