1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2.
REMOVE RADIATOR SUPPORT OPENING COVER
Remove the 2 clips.
Partially remove the radiator support opening cover.
HINT:
It is not necessary to fully remove the radiator support opening cover. Partially remove it so that the bumper cover can be removed later.
3.
REMOVE NO. 1 ENGINE COVER
Detach the 4 clips and remove the engine cover.
4.
REMOVE NO. 1 ENGINE UNDER COVER
Remove the 4 bolts, 12 clips and engine under cover.
5.
REMOVE ENGINE UNDER COVER REAR LH
Remove the 2 clips and under cover.
6.
REMOVE ENGINE UNDER COVER REAR RH
Remove the 2 clips and under cover.
7.
DRAIN ENGINE COOLANT
Loosen the radiator drain cock plug.
HINT:
Collect the coolant in a container and dispose of it according to the regulations in your area.
Remove the radiator reservoir cap.
CAUTION:
Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.