REMOVAL
Removal / installation · Vehicles built Nov 2005 – Jul 2008
Versions by build date: Nov 2005 – Jul 2008 from Aug 2008
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2.
REMOVE FRONT FENDER LINER LH |
 |
- Using a screwdriver, remove the clip and fender liner retainer.
Remove the screw, nut and bolt.
w/ Splash Shield:
Remove the front fender splash shield LH.
Partially remove the fender liner.
- HINT:
- It is not necessary to fully remove the fender liner. Partially remove it so that the bumper cover can be removed later.
| 3.
REMOVE FRONT FENDER LINER RH |
 |
- HINT:
- Use the same procedures described for the LH side.
| 4.
REMOVE RADIATOR SUPPORT OPENING COVER |
 |
- Remove the 2 clips.
Partially remove the radiator support opening cover.
- HINT:
- It is not necessary to fully remove the radiator support opening cover. Partially remove it so that the bumper cover can be removed later.
| 5.
REMOVE RADIATOR GRILLE PROTECTOR |
 |
- Remove the 2 radiator grille protectors.
| 6.
REMOVE FRONT BUMPER COVER |
 |
- Remove the 8 screws.
- Apply protective tape under the front fender and headlight.
Using a screwdriver, detach the 4 claws.
- HINT:
- Tape the screwdriver tip before use.
w/ Fog Light:
Disconnect the 2 fog light connectors.
w/ Headlight Cleaner:
Disconnect the headlight cleaner.
- Using a clip remover, remove the hood cushion center.
- Using a clip remover, remove the 4 clips and front bumper cover.
| 7.
REMOVE NO. 2 FRONT BUMPER ENERGY ABSORBER (w/ Front Bumper Lower Absorber) |
 |
- Remove the absorber.
| 8.
REMOVE FRONT BUMPER ENERGY ABSORBER (w/ Front Bumper Lower Absorber) |
 |
- Remove the 2 absorbers.
| 9.
REMOVE FRONT BUMPER ABSORBER LOWER (w/ Front Bumper Lower Absorber) |
 |
- Remove the absorber.
| 10.
REMOVE FRONT BUMPER RETAINER (w/ Front Bumper Lower Absorber) |
 |
- Remove the bolt and retainer.
| 11.
REMOVE FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY (w/ Front Bumper Lower Absorber) |
 |
Detach 5 clamps and remove the wire harness.
- Remove the 8 bolts and reinforcement.
| 12.
REMOVE NO. 2 FRONT BUMPER ENERGY ABSORBER (w/o Front Bumper Lower Absorber) |
 |
- Remove the absorber.
| 13.
REMOVE FRONT BUMPER RETAINER (w/o Front Bumper Lower Absorber) |
 |
- Remove the bolt and retainer.
| 14.
REMOVE FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY (w/o Front Bumper Lower Absorber) |
 |
- Detach the 5 clamps and wire harness.
- Remove the 8 bolts and reinforcement.
| 15.
REMOVE FRONT BUMPER SIDE RETAINER LH |
 |
- Remove the bolt.
Using a screwdriver, detach the clip and remove the bumper side retainer.
- HINT:
- Tape the screwdriver tip before use.
| 16.
REMOVE FRONT BUMPER SIDE RETAINER RH |
 |
- HINT:
- Use the same procedures described for the LH side.