Wear protective gloves. Sharp areas on the front seat frame (w/ adjuster) may injure your hands.
HINT:
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
1.
INSTALL FRONT OUTER SEAT TRACK ASSEMBLY
LH
2.
INSTALL FRONT INNER SEAT TRACK ASSEMBLY LH
Attach the 2 springs to install the seat track adjusting handle as shown in the illustration.
Temporarily install the front seat frame (w/ adjuster) with the 8 bolts.
Using a T40 "TORX" socket, tighten the 8 bolts.
Torque:
25 N*m{
255 kgf*cm
, 18 ft.*lbf
}
Using a T50 "TORX" socket, install the inner seat track bracket with the 2 bolts.
Torque:
29 N*m{
296 kgf*cm
, 21 ft.*lbf
}
3.
INSTALL SEAT POSITION AIRBAG SENSOR (for Driver Side)
Using a 1 mm (0.039 in.) feeler gauge, install the seat position sensor.
NOTICE:
If the seat position sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat position sensor with a new one.
When installing the seat position sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
HINT:
Be sure that the clearance between the seat position sensor and the seat rail is within 0.6 mm to 1.4 mm (0.023 to 0.055 in.).
Using a T30 "torx" socket, tighten the "torx" screw to install the seat position sensor.
Torque:
8.0 N*m{
82 kgf*cm
, 71 in.*lbf
}
Make sure that the clearance between the seat position sensor and the seat rail is within 0.6 mm to 1.4 mm (0.023 to 0.055 in.).
Connect the connector.
Install the seat slide position sensor protector to the seat position sensor.
4.
INSTALL FRONT SEAT CUSHION LOWER SHIELD LH
Attach the claw to install the lower shield.
5.
INSTALL FRONT SEAT CUSHION LOWER SHIELD RH
HINT:
Use the same procedures described for the LH side.