2005-2008 RAV4 · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Nov 2005


INSPECT FUEL INJECTOR ASSEMBLY

  1. A116182
    Measure the resistance between the injector terminals.

    Standard resistance:
    11.6 to 12.4 Ω at 20°C (68°F)

    If the result is not as specified, replace the injector.

  1. Inspect the injector injection.

    CAUTION:
    Keep the injector away from sparks during the test.


    1. A088382E01
      Connect SST (fuel tube connector) to SST (hose), then connect them to the fuel pipe (vehicle side).
      SST
      09268-31011   (09268-41500, 90467-13001, 95336-08070)

    2. Install the O-ring to the fuel injector.

    3. A116183E02
      Connect SST (adapter and hose) to the injector, and hold the injector and union with SST (clamp).
      SST
      09268-31011   (09268-41110, 09268-41130, 09268-41310)

    4. Put the injector into the graduated cylinder.

      CAUTION:
      Install a suitable vinyl tube onto the injector to contain gasoline spray.

    5. Operate the fuel pump.

    6. A075915E04
      Connect SST (wire) to the injector and the battery for 15 seconds, and measure the injection volume with the graduated cylinder. Test each injector 2 or 3 times.
      SST
      09842-30080  

      Standard injection volume:
      76 to 92 cm3 (4.6 to 5.6 cu in.) per 15 seconds

      Standard difference between each injector:
      16 cm3 (1.0 cu in.) or less

  1. A116184
    Inspect the fuel leakage.

    1. Disconnect the SST (wire) tester probes from the battery and check the fuel leakage from the injector.

      Standard fuel drop:
      1 drop or less per 12 minutes

    2. Turn the ignition switch off.

    3. Remove SST.

      SST
      09842-30080  

    4. Disconnect the intelligent tester from the DLC3.

    5. Reconnect the fuel inlet hose (rear fuel pipe) to the fuel main tube.

← REMOVAL (from Aug 2007)INSTALLATION (from Nov 2005) →