P0724 Brake Switch "B" Circuit High
Diagnostic trouble codes · Vehicles built from Aug 2007
DESCRIPTION
The purpose of this circuit is to prevent the engine from stalling while driving in the lock-up condition when the brakes are suddenly applied.When the brake pedal is depressed, this switch sends a signal to the ECM. Then the ECM cancels the operation of the lock-up clutch while braking is in progress.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0724 |
Stop light switch remains ON even when vehicle is driven in GO (30 km/h (18.63 mph) or more) and STOP (less than 3 km/h (1.86 mph)) pattern 5 times (2 trip detection logic) |
|
MONITOR DESCRIPTION
This DTC indicates that the stop light switch remains ON. When the stop light switch remains ON during GO and STOP driving, the ECM interprets this as a fault in the stop light switch. Then the MIL illuminates and the ECM stores the DTC. The vehicle must GO (30 km/h (18.63 mph) or more) and STOP (less than 3 km/h (1.86 mph)) 5 times for 2 driving cycles in order for the DTC to be output.WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- NOTICE:
- In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
- Warm up the engine.
- Turn the ignition switch OFF.
- Connect the intelligent tester to the DLC3.
- Turn the ignition switch ON and turn the tester ON.
- Enter the following menus: Powertrain / Engine and ECT / Data List.
- Follow the instructions on the tester and read the Data List.
| Tester Display |
Measurement Item/Range |
Normal Condition |
Diagnostic Note |
| Stop Light Switch |
Stop light switch status/ ON or OFF |
|
- |
| 1. INSPECT STOP LIGHT SWITCH ASSEMBLY |
Remove the stop light switch.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Switch Position
Specified Condition
1 - 2
Switch pin pushed in
10 kΩ or higher
Switch pin free
Below 1 Ω
3 - 4
Switch pin pushed in
Below 1 Ω
Switch pin free
10 kΩ or higher
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH ASSEMBLY - ECM) |
![]() ![]() |
Install the stop light switch assembly.
Measure the voltage according to the value(s) in the table below when the brake pedal is depressed and released.
- Standard voltage:
Tester Connection
Condition
Specified Condition
A12-36 (STP) - Body ground
Brake pedal is depressed
11 to 14 V
Brake pedal is released
Below 1 V
|
|
||||
| OK | ||
| ||

