2005-2008 RAV4 · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Aug 2007


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

  1. A173728
    Disconnect the mass air flow meter connector.

  1. Disconnect the VSV (air intake control) connector.

  1. Disconnect the 2 wire harness clamps and 2 vacuum hoses.

  1. Disconnect the No. 2 ventilation hose from the air cleaner hose.

  1. Loosen the No. 1 air cleaner hose clamp.

  1. Unfasten the 2 hook clamps, and then remove the air cleaner cap.

  1. Remove the air cleaner filter element from the air cleaner case.


3. REMOVE AIR CLEANER CASE
  1. Disconnect the harness clamp.

  1. A137898
    Remove the 3 bolts and air cleaner case.


4. REMOVE ECM

  1. A124570
    Remove the 3 bolts of the ECM bracket.

  1. A124571E01
    Disconnect the 2 ECM connectors.

    NOTICE:
    After disconnecting the connector, make sure that dirt, water and other foreign matter does not contact the connecting part of the connector.


    1. Push the locks on the 2 levers, then raise the levers, and disconnect the 2 ECM connectors.

  1. Remove the ECM with bracket.

  1. A124573
    Remove the 4 screws and 2 ECM brackets.

← COMPONENTS (from Aug 2007)INSTALLATION (from Aug 2007) →