2005-2008 RAV4 · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Nov 2005


CHECK ACCELERATOR PEDAL POSITION SENSOR

  1. B127990E01
    Check the voltage.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch on (IG).

    3. Turn the intelligent tester ON.

    4. Select the menu items: Powertrain / Engine and ECT / Data List / Accelerator Position 1 and Accelerator Position 2.

    5. Operate the accelerator pedal, and then check that the Accelerator Position 1 and Accelerator Position 2 values are within the specifications.

      Standard voltage (Accelerator Position 1):
      Accelerator Pedal Condition
      Specified Condition
      Released
      0.6 to 1.0 V
      Depressed
      3.4 to 3.8 V

      Standard voltage (Accelerator Position 2):
      Accelerator Pedal Condition
      Specified Condition
      Released
      1.4 to 1.8 V
      Depressed
      4.2 to 4.6 V

      If the result is not as specified, check the accelerator pedal rod, wire harness or ECM.

← COMPONENTS (from Nov 2005)REMOVAL (from Nov 2005) →