MIL Circuit
Circuit diagnosis · Vehicles built from Aug 2007
DESCRIPTION
The MIL (Malfunction Indicator Lamp) is used to indicate vehicle malfunction detections by the ECM. When the ignition switch is turned ON, power is supplied to the MIL circuit, and the ECM provides the circuit ground which illuminates the MIL.The MIL operation can be checked visually: When the ignition switch is first turned ON, the MIL should be illuminated and should then turn off. If the MIL remains illuminated or is not illuminated, conduct the following troubleshooting procedure using the intelligent tester.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK THAT MIL IS ILLUMINATED |
Perform troubleshooting in accordance with the table below.
- Result:
Condition
Proceed to
MIL remains ON
A
MIL does not illuminate
B
|
|
||||
| A | |
| 2. CHECK WHETHER MIL TURNS OFF |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position and turn the tester on.
Select the following menu items: Powertrain / Engine and ECT / DTC.
Check if any DTCs have been stored. Note down any DTCs.
Clear DTCs (Click here).
Check if the MIL goes off.
- Standard:
- MIL should go off.
|
|
||||
| NG | |
| 3. CHECK WIRE HARNESS (CHECK FOR SHORT IN WIRE HARNESS) |
Disconnect the ECM connector.

Turn the ignition switch to the ON position.
Check that the MIL is not illuminated.
- OK:
- MIL is not illuminated.
Reconnect the ECM connector.
|
|
||||
| NG | |
| 4. CHECK WIRE HARNESS (COMBINATION METER - ECM) |
Disconnect the ECM connector.

Disconnect the combination meter connector.
Measure the resistance.
- Standard resistance:
Tester Connection
Specified Condition
A12-24 (W) or E22-8 (EFI) - Body ground
10 kΩ or higher
Reconnect the ECM connector.
Reconnect the combination meter connector.
|
|
||||
| NG | ||
| ||
| 5. CHECK THAT MIL IS ILLUMINATED |
Check if the MIL is illuminated when the ignition switch is turned ON.
- OK:
- MIL should be illuminated.
|
|
||||
| NG | |
| 6. CHECK THAT ENGINE STARTS |
Turn the ignition switch to the ON position.
Start the engine.
- Result:
Result
Proceed to
Engine starts
A
Engine does not start*
B
- HINT:
- *: The intelligent tester cannot communicate with the ECM.
|
|
||||
| A | |
| 7. INSPECT COMBINATION METER ASSEMBLY (MIL CIRCUIT) |
Check the MIL circuit (Click here).
|
|
||||
| OK | ||
| ||
