2005-2008 RAV4 · Service Manual ENGINE

Air Intake Control Circuit

Circuit diagnosis · Vehicles built from Aug 2007

DESCRIPTION

The air cleaner is equipped with 2 inlets, one of which is opened or closed by the Air Intake Control Valve (AICV). This system reduces intake noise and increases engine power at low to high engine speeds range.
When the engine is operating in the low-to-mid speed range, this control operates the AICV to close one of the air cleaner inlets. When the engine speed is more than 3600 rpm and the opening angle of the throttle valve is more than 60°, the ECM activates the VSV and opens the AICV.
A061332E09

WIRING DIAGRAM

A136798E07

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (AICV VSV)

  1. A057013E03
    Turn the ignition switch to the ON position and turn the intelligent tester on.

  1. Select the following menu items: Powertrain / Engine and ECT / Active Test / Activate VSV for AICS.

  1. Check the operation of the VSV when the VSV is operated by the intelligent tester.

    Standard:
    Tester Operation
    Specified Condition
    VSV is ON
    Air from port E flows out through port F
    VSV is OFF
    Air from port E flows out through the air filter



OK
Go to step 4
NG


2. INSPECT AICV VSV
  1. Inspect the AICV VSV (Click here).



NG
REPLACE INTAKE AIR CONTROL VALVE ASSEMBLY
OK


3. INSPECT VACUUM TANK
  1. Inspect the vacuum tank (Click here).



NG
REPLACE AIR CLEANER CAP
OK


4. CHECK VACUUM PIPING (HOSE AND INTAKE MANIFOLD, VACUUM TANK)


NG
REPAIR OR REPLACE VACUUM LEAKAGE POINT
OK

REPAIR COMPLETED


← Fuel Pump Control Circuit (from Aug 2007)MIL Circuit (from Aug 2007) →