2005-2008 RAV4 · Service Manual ENGINE

B2271 Ignition Hold Monitor Malfunction

Diagnostic trouble codes · Vehicles built from Jan 2007

DESCRIPTION

This DTC is output when the IG output circuits inside the main body ECU are open or short.
DTC No.
DTC Detection Condition
Trouble Area
B2271
IG1 relay actuation circuit or IG2 relay actuation circuit inside main body ECU is abnormal
  1. Main body ECU
  2. AM2-2 fuse
  3. Wire harness or connector

WIRING DIAGRAM

A165870E01

INSPECTION PROCEDURE


1. CHECK WHETHER DTC OUTPUT RECURS
  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG) and turn the tester ON.

  1. Clear the DTCs.

  1. Start the engine.

  1. Allow the engine to idle for 1 minute or more.

  1. Select the following menu items: Body / Body ECU / DTC.

  1. Read the DTCs.

    Result:
    Display (DTC output)
    Proceed to
    B2271
    A
    No DTC output
    B



B
END (SYSTEM IS OK)
A


2. INSPECT FUSE (AM2-2)
  1. Remove the AM2-2 fuse from the No. 1 relay block.

  1. Check the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


3. CHECK WIRE HARNESS (MAIN BODY ECU - BATTERY AND BODY GROUND)

  1. B127996E02
    Disconnect the E18 and E19 main body ECU connectors.

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Specified Condition
    E19-1 (AM1) - Body ground
    10 to 14 V
    E18-6 (AM2) - Body ground
    10 to 14 V

    Standard resistance:
    Tester Connection
    Specified Condition
    E19-4 (GND2) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE INSTRUMENT PANEL JUNCTION BLOCK (MAIN BODY ECU)


← DIAGNOSTIC TROUBLE CODE CHART (from Jan 2007)B2272 Ignition 1 Monitor Malfunction (from Jan 2007) →